Welding symbol terms to complete your job smoothly:

Reference Line: Drawn always as a horizontal line Arrow: Drawn from either end of the reference line. It always touches the line that represents the welded joint Tail: Used only if necessary , when to give information on some specifications Weld Symbol: Suggests the type of weld to be made Arrow Side: The side of the…

Pre-power check-up about functionality of Inverter based welder:

The following procedure should be undertaken: Check the functionality of the Power Switch. Verify that it has continuity in the ON position, and equipped a disconnect (is open circuit) in the OFF position. Check all poles of the switch. If the Inverter is capable of operating at multiple input Voltages, confirm about the working of any external…

Welding Procedure: To Initiate and Complete Your Job Easily

Assembling the torch: Choose the appropriate diameter electrode by consulting the apparatus manual. It is very essential to appropriately prepare the electrode tip in order to get a good weld. If DC welding is to be performed, the tip must be sharpened just like a pencil. On the sander, hold the electrode at about a 20 degree angle…

Tips for Overhead TIG Welding:

Following are the major instructions to be taken care of by the welders about the overhead TIG welding technique:-  Broaden the electrode far as possible to obtain the correct torch angle  Control the electrode sharp, and if suppose gets cracked up, sharpen or replace it with a new sharp one  A flex head welding torch…